Omron F250-UME Software Manual page 268

Detecting Binary Defects
SeeAlso
STEP 2: Setting Measurement Conditions
SeeAlso
2-12-(25)
A list of region numbers will be displayed.
Select region
Region0
Region1
Region2
Region3
Region4
Region5
Region6
Region7
3. Select the region number.
The selection of measurement methods will be displayed.
New registration(Region0)
4. Select Area (var. box).
The initial Area Var. Box Screen will be displayed.
Region0(Area(var.box))
5. Select Binary.
The Binary Levels Settings Screen will be displayed.
The rest of the procedure is the same as outlined under
.
Refer to page 2-12-(4).
Set measurement conditions to measure the exterior of a measurement object
or to make the binary levels track the brightness of the measurement image.
The default for all settings is OFF.
Refer to page 2-12-(10) for information on the fill profile and binary tracking
functions.
Gravity and area
Gravity and axis
Area(var.box)
Binary
Measurement conditions
Left edge
Upper edge
Right edge
Lower edge
Reference registration
Judgement conditions
Section 2-12