Omron F250-UME Software Manual page 986

Troubleshooting
Error message
Process item cannot be registered.
Direction settings are not appropriate.
Cannot select this direction.
Background must not be same color as
Normal.
Communications error (Data transmis-
sion).
Communications error. (Normal)*
Communications error. (Host Link)*
Timeout error (Data transmission).
Timeout error. (Normal)*
Timeout error. (Host Link)*
Incorrect data format received.
Data are too large. Cannot save by
serial communication.
7-(6)
Causes and remedies
There is insufficient work memory.
Delete scenes and units that are not required.
Refer to
The following processing items cannot be registered before the first
Camera image unit.
- Switch camera
- Change filtering
- Filtering again.
- Select midpoint for X and Y when relative angle selected for
- Select the same region number for X and Y when region 0 or region 1
q
selected for .
Reason: Position cannot be compensated with the current combination.
Combine upper, lower, left, and right edge search directions that will
surround the area to be measured.
Reason: The selected directions do not surround the region to be
searched.
Refer to
Change one of the colors.
Refer to
Turn OFF the power to the Controller and check for the following items
before restarting the Controller.
- The cable is connected properly.
- The communications specifications for the external device and the
Controller are the same.
- The external device is operating properly.
Reason: Data transfer has been interrupted due to a communications
error in communications between the Controller and an external device.
If the same error message appears after restart, it may mean that the
Controller is faulty. Contact your OMRON representative.
Refer to the Setup Manual, and to
, and
Turn OFF the power to the Controller and check for the following items
before restarting the Controller.
- The cable is connected properly.
- The communications specifications for the external device and the
Controller are the same.
- The external device is operating properly.
Reason: Data transfer has been interrupted due to a timeout in commu-
nications between the Controller and an external device.
If the same error message appears after restart, it may mean that the
Controller is faulty. Contact your OMRON representative.
Refer to the Setup Manual, and to
, and
Select the correct transfer file and re-execute the data transfer.
Reason: The wrong file has been selected.
Reinstall the processing item.
Reason: The scene data or scene group data that was to be loaded
includes processing item(s) that are not currently installed to the Con-
troller.
Refer to
Save the data to a Memory Card or delete surplus data and then save.
Reason: Data 2MB and over cannot be saved via serial communica-
tions.
Refer to
.
and
.
.
.
Section 7-2
q
.
,
.
,
.