Omron F250-UME Software Manual page 582

Lot Number OCV 1
2-24-9 Measurement Screens
SeeAlso
CHECK
Inspected Regions
2-24-(29)
Detailed measurement values can be displayed on the screen in Monitor and
Run modes. These values are useful when adjusting measurement conditions.
This section describes what kind of information can be displayed for the Lot
Number OCV1 processing item.
Refer to
Run modes.
Press the SHIFT+ESC Keys on the Run Screen to access the following screen
and change Display results to Details.
0.Scn 0
Use the Up or Down Key to change to the unit for which Lot Number OCV1 is
set and the following detailed screens will be displayed.
Use the SHIFT+Right or Left Keys to switch in order between the two
screens.
The judgement result for this unit, the set lot number, the inspected regions,
and the extraction frame for each number will be displayed.
• Auto Extract Mode
0.Scn 0 RUN
1. Lot-No. OCV1
Judge : OK
Lot-No. : 0123
• Fixed Extract Mode
0.Scn 0 RUN
1. Lot-No. OCV1
Judge : OK
Lot-No. : 0123
RUN NG
Image status
:
Freeze(Before scroll)
Display image
:Image0
Image size
: All
Display results
: Details
End
Image 0 Freeze
OK 45ms
Judgement result for this unit
Lot number that was set
Inspected region (solid lines)
Extraction frames (dotted lines)
OK 45ms
Judgement result for this unit
Lot number that was set
Inspected region (solid lines)
Extraction frames (dotted lines)
Section 2-24
for details on Monitor and
67ms