Omron F250-UME Software Manual page 649

Calculation
CHECK
To find the distance between the 2 measurement region points in example 1
and then add 120.25 to that value.
Calculation0.
DIST(U1.R00X,U1.R00Y,U2.R00X,
U2.R00Y)
Measurement :
Upper :
[
Lower : [
Calculation1.
U3.D00+120.25
Measurement :
Upper :
[
Lower : [
If the expression was set in the reverse order
Calculation0.
U3.D01+120.25
Measurement :
Upper : [
Lower : [
Calculation1.
DIST(U1.R00X,U1.R00Y,U2.R00X,
U2.R00Y)
Measurement :
Upper : [
Lower :
[
Example 2: Counting the number of measurements
Calculation0.
Measurement :
Upper
Lower
U3.D00 will return to "0" if the measurement value is cleared or the power is
turned OFF so the count of the number of measurements will also be reset.
Find the distance between 2 points.
158.121
180.000]
130.000]
Add 120.25 to the result for calculation 0.
158.121
180.000]
130.000]
Calculation 0 would be calculated before
calculation 1 and the previous calculation
result for U3.D01 would be used.
158.121
180.000]
130.000]
158.121
180.000]
130.000]
U3.D00+1
0.000
:
[ 0.000]
: [ 0.000]
ENT:Change
Section 2-29
2-29-(27)