Operational Flow - Omron F250-UME Software Manual

Operational Flow

1-2 Operational Flow
Preparations
SeeAlso
Setting Detection Conditions
Confirming Settings and Executing
Selecting Processing Items that Suit the Application
Changing and Deleting Settings
Saving Settings
Application Setting Operations
Additional Functions
Troubleshooting
HELP
HELP
HELP
Install the Application Software in the Controller. Refer to 1-3 Installing the
Application Software.
Refer to 1-6 Basic Operations to learn about the basic operational flow from
setting detection conditions to executing measurements.
STEP 1: Make the settings required to input images. Refer to1-6-1 STEP 1:
Settings for Image Input.
STEP 2: Make settings to correct positioning. Refer to 1-6-2 STEP 2: Settings
for Position Displacement Compensation.
STEP 3: Set the actual measurement methods. Refer to 1-6-3 STEP 3: Setting
Measurement Methods.
STEP 4: Make settings to output the results. Refer to 1-6-4 STEP 4: Setting
Results Output Methods.
STEP 5: Perform test measurements and start executing measurements.
Refer to 1-6-5 STEP 5: Start Test or Measurement and to SECTION 3 Monitor
Mode and Run Mode.
Refer to SECTION 2 Processing Items Setting Procedures.
Copy, clear, and change units and unit names by refer to
1. Save detection conditions. Refer to 1-8 Saving Settings and Shutting
Down.
2. Back up image, system, and scene data. Refer to 4-2 Backing Up Data for
information on how to back up settings.
1. Set conditions by product type. Refer to 4-1 Changing Scenes and Scene
Groups for information on scene and scene-group functions.
2. Set system environment conditions. Refer to SECTION 5 System Settings.
3. Initialize the measurement conditions that have bee set. Refer to 4-1-3 Ini-
tializing Measurement Conditions: Clearing Scenes and 7-1 Set Up Menu.
4. Set communications specifications and I/O format for communications with
external devices. Refer to SECTION 6 Communicating with External De-
vices.
1. Use Memory Cards if required. Refer to 4-6 Memory Card Operations.
2. Check communications status with external devices if required. Refer to 4-
5 Checking I/O Status with External Devices.
When an error message is displayed on the screen, refer to 7-4 Terminology.
If you have a question, refer to 7-3 FAQ.
If you don't understand a term, refer to 7-4 Terminology.
.
Section 1-2
1-(3)