Omron F250-UME Software Manual page 912

Normal Serial Interface
Note If these settings are changed, one rectangular region will be set and any previ-
CHECK
6-2-(62)
Data
The following settings data is for gravity and area.
Settings 205 Inspection
data region 0
206
207
208 Inspection
region 1
to
The following settings data is for gravity and area.
Settings 394 Inspection
data region 7
to
424
ously drawn figures will be deleted. This is true for regions 1 to 7 as well.
Only the allocations for region 0 are listed here. Refer to the allocations for
region 0 to calculate the numbers for regions 1 to 7.
Details
Skipping X (1 to 15)
Skipping Y (1 to 15)
Fill profile
0: OFF
1: ON
Region upper left X (0 to 511)
... (Same as for inspection region 0)
Region upper left X (0 to 511)
... (Same as for inspection region 0)
Fill profile
0: OFF
1: ON
Section 6-2