Omron F250-UME Software Manual page 848

Parallel Interface
Inputting Measurement Triggers to STEP Signal
Enter Run Mode
OFF
RUN
ON
STEP input
OFF
BUSY
ON
OR
DO
OFF
GATE
ON
CHECK
Switching Scenes or Scene Groups
Enter Run Mode
OFF
RUN
ON
DI0 to 6
OFF
DI7
ON
OFF
BUSY
ON
6-1-(13)
Example: When Num. of delays is Set to 2
STEP input
(1) (2)
Measuring
Overall judgement
for (1)
(No results output)
The functions of the I/O signals are the same as when output control is set to
None.
Executing command
Output Signals
Signal
RUN ON while the Controller is in Run Mode.
BUSY Indicates that the Controller is switching scenes or scene groups. Do not
input the next command while the BUSY signal is ON. If another command
is input while the BUSY signal is ON, either the operation being performed
or the command that was input may not be properly executed.
Input Signals: Switching the Scene
Signal
DI0 to Set the scene number (0 to 31).
DI4
DI5 ON
STEP input STEP input
(3) (4)
Overall judgement Overall judgement
for (2) for (3)
Result for Result for
(1) (2)
Gate ON Gate ON
delay time
Function
Function
Section 6-1
Exit Run Mode
STEP input
(5)
Overall judgement
for (4)
Result for
(3)
Exit Run Mode