Omron F250-UME Software Manual page 857

Normal Serial Interface
CHECK
SeeAlso
The Communications (Serial) window will be displayed.
Communications (Serial)
5. Set each parameter to the desired setting.
6. Select End.
The displayed settings will be registered and the System settings menu
(from step 3) will be displayed.
The following table shows the possible communications settings. The as-
terisk (*) indicates the default setting
Item
Interface RS-232C* or RS-422
Baud rate 2,400, 4,800, 9,600, 19,200, 38,400*, 57,600,
(See note a.) 115,200 (bps)
Data length 7 or 8* (bits)
Parity bits None*, Odd, or Even
Stop bits 1* or 2 (bits)
Mode Select Normal.
Transfer protocol XMODEM*, ZMODEM
(See note b.)
Note a) RS-232C standards are not defined for speeds over 20 kbps. De-
pending on the cable length, communications may be unreliable
at speeds of 38,400 bps and higher when RS-232C is selected.
If there are problems with communications, reduce the baud rate
to 19,200 bps.
b) XMODEM (-1K) is not supported.
Make the following settings when saving or loading with commands such
as SCNLOAD and SCNSAVE.
Item
Data length 8 bits
Parity bits None
Stop bits 1 bit
Flow control None
Refer to
flow control.
:
Interface
RS-232C
:
Baud rate 38400bps
:
Data length 8bit
:
Parity bits
None
:
Stop bits
1bit
:
Mode Normal
:
Protocol XMODEM
End
.
Possible settings
Possible settings
Section 6-2
Set the same
settings that
are set in the
personal com-
puter.
Set the same
settings that
are set in the
personal com-
puter.
for details on setting the
6-2-(7)