Display String - Omron F250-UME Software Manual

Display String

2-43 Display String
CHECK
CHECK
Operational Flow
STEP 1: Setting Display Characters
The Display String processing item is used to display any characters on the
Run and Monitor Mode screens.
Example: Displaying Measurement Details in Combination with Display Mea-
surement Processing Item
0.Scn 0 RUN
Difference from reference: 20
Use this processing item to display any alphanumeric characters in Run and
Monitor Modes.
The data set here will be enabled when None or Positions is selected under
System/Display/Display settings/Display results.
Even when the display image is set to be displayed as a reduced image, the
characters will always be displayed in the specified position.
STEP 1
Set display
characters.
Up to 29 standard size alphanumeric characters can be set. The characters
can be selected from the list of characters on the displayed software keyboard.
1. Select Display string.
0.Scn 0=SET=
ENT:Set SFT+ESC:Edit
Measurement details
OK 45ms
Image 0 freeze
STEP 2
Set display
conditions.
0.Camera image
1.Binary pos. comp
2.Edge position
3.Calculation
4.Display string
5.
Section 2-43
Measurement result
STEP 3
Set display
position.
2-43-(1)