Table of Contents
Advertisement
Lot Number OCV 1
CHECK
Correcting Fixed Regions
2-24-(25)
2.
Select 1st digit.
The region setting screen will be displayed.
Inspected region
3.
Draw the inspected region for the first digit as a square block.
Specify the upper left and lower right coordinates.
Up/Down/Left/Right Keys:
ENT Key:
When the lower right coordinates have been specified, the inspected re-
gion will be set and digit number selection screen will be displayed.
Inspected region
4.
Draw inspected regions for the other digits in the same way as for the first.
5.
When regions have been drawn for all digits, press the Esc Key from the
digit selection screen.
The screen in (1.) will return.
If the number of digits set for the lot number in the measurement conditions
is changed, all of the inspected regions will be cleared. Repeat the settings
from (1.).
1.
Select the digit for which the region is to be corrected.
The selected region will be displayed in solid lines.
Inspected region
Move the cursor.
Confirms the setting.
1st digit
2st digit
3st digit
1st digit
2st digit
3st digit
Section 2-24
271,225
Advertisement
Chapters
Table of Contents
