Measurement Screen Settings - Omron F250-UME Software Manual

Screen Display and Monitor
5-3-2

Measurement Screen Settings

Scene/Mode
Select whether or not to display
the scene and mode.
0.Scn 0
1.Fine matching
Judge
Quantity :
Area
Gravity X :290.000
Gravity Y :280.000
CHECK
SeeAlso
5-(6)
Set the items below to determine the information displayed in Run Mode and
Monitor Mode. The display settings made here will be reflected in all scenes.
Overall Judgement
Select whether or not to display the overall judgement.
MON NG
:NG
1
:12
Image 0 freeze
Image Type
Select whether or not to display these items.
Display Results
Select whether or not to display detailed measurement results, e.g., detailed results
for each unit.
Scene/Mode
Even if Scene/Mode is set to not be displayed, the scene or mode can be dis-
played temporarily by pressing the ENT Key. However, measurement cannot
be performed while the scene or mode is being displayed this way. Press the
ESC Key again to turn OFF the display.
1. Enter System mode and select Display.
Refer to
The Display Settings/Monitor/Designate Colors/Make Colors Menu will be
displayed.
2. Select Display settings.
Processing Time
67ms
Select whether or not to display the processing
time.
Display Image
Select which image to display, the image stored
at Image 0 or the image stored at Image 1.
Image Status
Select the type of image to display.
Image Size
Select whether to display a full-screen or
reduced image.
.
Character size
Display settings
Monitor
Designate colors
Make colors
Section 5-3