Omron F250-UME Software Manual page 457

Pattern
2-20-2 Setting Measurement Regions
STEP 1: Registering the Model
CHECK
Up to 64 regions can be set.
1
Register
model.
The area of the image to be inspected is registered as a model.
When a model is registered, the center position of the model is registered as
the search coordinates. When several figures have been combined in the
drawing, the center coordinates of circumscribing rectangle becomes the
search coordinates.
Regions can be created by combining up to 3 different figures. Regions with
difficult shapes can be drawn and sections not to be measured can be left out
of the region by combining different figures.
1. Select Pattern.
ENT:Set SFT+ESC:Edit
The settings selections will be displayed.
1.Pattern
2 (As required) 3
Change Set search
search region.
coordinates.
0.Scn 0=SET=
0.Camera image
1.Pattern
2.
Measurement conditions
Select region
Detailed conditions
Coordinate mode
Section 2-20
4
Set
judgement
conditions.
2-20-(4)