Revision History - Omron F250-UME Software Manual

A manual revision code appears as a suffix to the catalog number on the front cover of the manual.
The following table outlines the changes made to the manual during each revision. Page numbers
refer to the previous version.
Revision code
01 August 2001
02 December 2001

Revision History

Cat. No. Z153-E1-02
Date
Original production
"F250" was globally changed to either "Controller" or "Application Soft-
ware" to more clearly distinguish between hardware and software.
"Trim" was changed to "extract" in relation to QUEST Character Verifica-
tions and Lot Number OCU 1.
Pages 1-2, 2-507, 2-511, 2-518, 6-26, 6-32, 6-43, 6-63, and 6-102: Infor-
mation was added on new processing items and commands.
Pages 1-3 and 1-63: "Exit" was changed to "turn power OFF."
Pages 1-46, 1-47, 2-20, 2-30, 2-37, 2-45, 2-70, 2-75, 2-80, 2-81, 2-83, 2-
84, 2-86 to 2-88, 2-90, 2-93, 2-94, 2-96, 2-229, 2-230, 2-257, 2-265, 2-
271, 2-305, 2-310, 2-316, 2-317, 2-319, 2-320, 2-322 to 2-325, 2-328, 2-
329, 2-330, 2-331, 2-357, 2-460, 2-492, 2-506, 2-559, 4-21, 5-39, 6-8, 6-
19, 6-115, 6-130, 7-4, and 7-7 to 7-11: General information or revisions
were added.
Pages 1-48, 2-33, 2-270, 2-428, 2-429, 2-541 to 2-543, 2-546, 2-556, 2-
562, 2-587, 2-573, 2-597, 2-601, 2-606, 2-609, 2-613, 2-618, 4-22, 5-7,
5-17 to 5-20, 5-22, 5-23, 5-36, 6-75, 6-90, 6-110, 6-130, and 7-13: Cor-
rections were made.
Pages 2-228 and 2-243: Graphics were removed.
Pages 5-25 to 5-29 and 6-35: Pages and information were removed.
Revision code
Revised content