Omron F250-UME Software Manual page 341

EC Defect
2-15-3 Setting Removal Regions
Set the figures to be removed. The figures can be chosen separately for each
region.
The inspection target can be limited to the defect if the outline of the measure-
ment object or other regions are set to be removed.
Set the figures to be removed. Removal
processing is set for an edge-extracted image.
Removal region 0
Removal region 1
Remove left edge.
Removal region 3
Inspection is performed for inspection regions 0
to 7 for the "removal image," i.e., the image from
which the set shapes have been removed.
Original image
Remove top edge.
Remove bottom edge.
Section 2-15
Defect
Removal region 2
Remove right edge.
Removal region 4
A circle of this size will
be removed.
See
to
check the results.
2-15-(8)