Backing Up To A Personal Computer - Omron F250-UME Software Manual

Backing Up Data
4-2-1

Backing Up to a Personal Computer

Saving Data to the Computer
4-(10)
This section describes the procedure for data transfer using Hyper Terminal,
which is standard software in Windows.
If other communications software is being used, refer to the relevant manual.
Data communications are performed in XMODEM (-CRC or -SUM) or ZMO-
DEM protocols. XMODEM (-1K) is not supported.
Controller
1. Connect the personal computer and the Controller.
2. Make the Controller communications settings (serial).
The default communications settings are as shown in the following table.
These settings can normally be used.
Item
Interface
Baud rate
Data length
Parity bits
Stop bits
Protocol
Note XMODEM and ZMODEM transfer protocols are available. Use the
protocol that matches the personal computer settings.
3. Start the Hyper Terminal program on the computer and make the following
communications settings. The same communications settings must be
used on both the Controller and the modem on the computer.
For RS-232C and RS-422 Connections
Item
Connection COM*
method
(*: COM number to which the cable is
connected)
Baud rate 38,400 (bps)
Data length 8 (bits)
Parity bits None
Stop bits 1 (bit)
Flow control None
For Ethernet Connections
Item
Connection TCP/IP (Winsock)
method
Host address IP address of Controller
Port number 23 (TELNET)
Data
Personal computer
Setting
RS-232C
38,400 (bps)
8 (bits)
None
1 (bit)
XMODEM (See note.)
Setting
Setting
Section 4-2