Omron F250-UME Software Manual page 16

Installing the Application Software
CHECK
SeeAlso
1-(8)
3. Press the ENT Key.
The Main Screen for the Setup Menu will return.
Set up
4. Turn OFF the power supply to the Controller.
5. Remove the F250-UME from Memory Card slot 0.
6. Turn ON the Controller power supply.
If the power is turned ON while the F250-UME is still mounted, the Setup
Menus will open. Always remove the F250-UME before turning ON the power
supply.
After a while the Camera Settings Screen will be displayed.
Camera settings
Refer to page SECTION 5 System Settings.
7. Select the camera to be connected.
8. If using Intelligent Lighting, select the model.
9. Select END.
The Basic Screen will be displayed.
0.Scn 0
Select items
Install
Backup data load
Clear memory
Camera :F160-S1
Intelligent Lighting 0:
Out of use
Intelligent Lighting 1:
Out of use
Intelligent Lighting 2:
Out of use
Intelligent Lighting 3:
Out of use
End
MON
Image 0 freeze
Section 1-3
---- ---ms