Backing Up To Flash Memory - Omron F250-UME Software Manual

Backing Up Data
4-2-3

Backing Up to Flash Memory

Precaution
Precaution
4-(20)
The scene data set to scene group 0 and system data will be saved to the
Controller internal flash memory. If this save operation is performed for scene
groups 1 to 31, the data will overwrite the contents of the files on the Memory
Card.
Flash memory and Memory Card data is loaded each time the Controller is
started up. Therefore, when settings have been changed, be sure to save to
flash memory before turning the power OFF. If the power is turned OFF with-
out saving, all of the setting changes will be lost.
1. Display the Basic Screen for Monitor Mode or Run Mode.
0.Scn 0
2. Move the cursor to MON (or RUN) and press the ENT Key.
The mode selections will be displayed.
0.Scn 0
3. Select SAVE.
A confirmation message will be displayed.
4. Select Execute.
Do not turn OFF the power or input a RESET signal while a message is
being displayed in any save or load operation. Data in memory will be de-
stroyed, and the Controller may not operate correctly the next time it is
started.
When saving has been completed, the screen for step 1 will return.
---- ---ms
MON
Image 0 freeze
---- ---ms
MON
SET
MON
RUN
SYS
TOOL
SAVE
Setting data will be saved.
Execute Cancel
Section 4-2