Omron F250-UME Software Manual page 63

Basic Operations
1-6-3-7 Setting the Coordinate Mode
Coordinate mode
Output coordinate:
After scroll
Calibration
End
The asterisk (*) indicates the default setting.
CHECK
When outputting the defect position coordinates, select the type of coordi-
nates.
Before scroll:Output made using the coordinate values before
After scroll*: Output made using the coordinate values after
: OFF
ON:
OFF*: Output made using Camera coordinate values
If the coordinate mode is changed after the judgement conditions have been
set, the measurement results will change also. Change the judgement condi-
tions to enable correct measurement.
1. Select Coordinate mode.
1.Fine matching
The Coordinate Mode Settings Screen will be displayed.
Coordinate mode
2. Make the settings for each item.
3. Select End.
The settings will be registered and the screen in (1.) will return.
position displacement compensation
position displacement compensation
Refer to 7-4 Terminology for differences between
output coordinates.
Output made using coordinate values set using calibration
Measurement conditions
Labeling
Model registration
Judgement conditions
Differencial image
Detailed conditions
Coordinate mode
Model reference
Output coordinate:
After scroll
Calibration : OFF
End
Section 1-6
1-(55)