Omron F250-UME Software Manual page 208

Circle Position Compensation
2-9-(5)
The Model Registration Screen will be displayed.
Model registration
4. Specify the coordinates for the center of the circle.
Up/Down/Left/Right Keys: Move the display cursor.
5. Press the ENT Key.
The screen for specifying the radius will be displayed.
Model registration
6. Specify the size of the circle.
Left Key: Decreases the size.
Right Key: Increases the size.
7. Press the ENT Key.
The screen for registering the size of the model will be displayed.
Model registration
8. Adjust the size of the model.
Right Key: Increases the size horizontally.
Left Key: Decreases the size horizontally.
Down Key: Increases the size vertically.
Up Key: Decreases the size vertically.
When the size of model 0 is adjusted, models 1 to 3 will also change to the
same size.
Section 2-9
255,241
70
39,39