Basic Operations - Omron F250-UME Software Manual

Basic Operations

1-6 Basic Operations
1-(28)
This section describes the basic flow of operations up to the setting of mea-
surement conditions and executing measurements. The explanation is based
on the use of the Fine Matching processing item for the measurement method.
Detecting Label Defects
Minor defect
step
step
step
step
step
0.Scn0 RUN NG
Printing defect
Edge defect
1
Settings for image input
2
Settings for position
displacement compensation
of measurement object
3
Setting measurement method
4
Settings for measurement
result output method
5
Start test or measurement.
Section 1-6
Pattern defects