Omron F250-UME Software Manual page 921

Normal Serial Interface
Fine Matching (Settings Data)
Data
Settings 32 Coordinate mode
data
0: After scroll, calibration OFF
1: Before scroll, calibration OFF
2: After scroll, calibration ON
3: Before scroll, calibration ON
33 Boundary inspection
0: OFF
1: ON
34 Defect inspection
0: Labeling area
1: Binary area
35 Target
0: Black
1: White
2: Both
36 Area lower limit (0 to 9,999,999.999)
37 Area upper limit (0 to 9,999,999.999)
38 Sort
0: Area descending 1: Area ascending
2: X gravity descending 3: X gravity ascending
4: Y gravity descending 5: Y gravity ascending
39 Label number (0 to 999)
40 Boundary level (1 to 5)
41 Difference (0 to 255) (See note 1.)
42 Perturbation
0: OFF
1: ON
43 Normalization
0: OFF
1: ON
44 Defect display
0: Simple
1: Detail
45 Model registration area upper left X (0 to 511) (See note 2.)
46 Model registration area upper left Y (0 to 483) (See note 2.)
47 Model registration area lower right X (0 to 511) (See note 2.)
48 Model registration area lower right Y (0 to 483) (See note 2.)
49 Quantity upper limit (0 to 1,000)
50 Quantity lower limit (0 to 1,000)
51 Area upper limit (0 to 9,999,999.999)
52 Area lower limit (0 to 9,999,999.999)
53 Position X upper limit (-9,999.999 to 9,999.999)
54 Position X lower limit (-9,999.999 to 9,999.999)
55 Position Y upper limit (-9,999.999 to 9,999.999)
56 Position Y lower limit (-9,999.999 to 9,999.999)
57 Difference (white) (0 to 255) (See note 1.)
58 Difference (black) (0 to 255) (See note 1.)
Section 6-2
Details
6-2-(71)