Omron F250-UME Software Manual page 83

Inputting Camera Images
Specifying
Coordinate Axis
The settings will be registered and the screen in (2.) will return.
This method is used to specify the coordinate axis while monitoring the mes-
sages displayed on the screen. The coordinate system, the origin, the rotation
angle, and the magnification, are set in that order. The magnification for X and
Y directions is the same setting when specifying the coordinate axis.
Coordinate System
Select the coordinate system.
Left-handed sytem
0
Origin
Y
1. Select Camera settings.
0.Camera image
The initial Camera Settings Screen will be displayed.
Camera settings
Shutter speed(Cam0)
Light control(Cam0)
Calibration(Cam0)
Shutter speed(Cam1)
Light control(Cam1)
Calibration(Cam1)
Shutter speed(Cam2)
Light control(Cam2)
2. Select Calibration.
The initial Calibration Screen will be displayed.
Calibration(Camera0)
3. Select Specifying coordinate axis.
Right-handed sytem
X
Origin
Positive direction
Camera settings
Select camera
Filtering order(Image0)
Filtering(Image0)
BGS levels(Image0)
Filtering order(Image1)
Filtering(Image1)
BGS levels(Image1)
Frame/Field
Sampling input
Specifying point
Specifying coordinate axis
Righthand
Parameter input
Lefthand
Reference parameter
Section 2-1
Y
Positive direction
0
X
2-1-(10)