Omron F250-UME Software Manual page 757

Changing Scenes and Scene Groups
4-1-1 Setting Measurement Conditions for Different Models:
Changing Scenes
Use the scene changing function to switch between different measurement
conditions for different measurement setups or measurement objects. Scene 0
will be displayed by default when the power is turned ON, however, the Con-
troller also accommodates scenes 1 to 31. If a Memory Card is inserted and
the scene group function used, up to 1,024 scenes can be set.
The command for changing scenes or scene groups can be input from an
external device via a parallel or serial interface.
1. Display the Basic Screen for Monitor Mode or Run Mode.
0.Scn 0
2. Move the cursor to Scn and press the ENT Key.
The Scn 0 to Scn 7 options will be displayed.
Use the Down Key to display scene numbers 8 to 31.
0.Scn 0
S+ESC:Edit S+ENT:Scn Group
3. Move the cursor to the scene number to be switched to and press the
ENT Key.
The selected scene will be displayed.
1.Scn 1
MON
Image 0 freeze
MON
0.Scn 0
1.Scn 1
2.Scn 2
3.Scn 3
4.Scn 4
5.Scn 5
6.Scn 6
7.Scn 7
↑ ↓
Image 0 freeze
MON
Image 0 freeze
Section 4-1
---- ---ms
---- ---ms
---- ---ms
4-(3)