Omron F250-UME Software Manual page 60

Basic Operations
1-6-3-6 Changing Detailed Conditions as Required
SeeAlso
1-(52)
3. Use the SHIFT+Left and SHIFT+Right Keys to switch between the white
defect and black defect images.
Differential image
(White)
SFT+
4. Move the cursor to the differential value (difference) and use the Left and
Right Keys to change the value.
Change the value until the defect is displayed in white.
Right Key: Increases the value by 1.
Left Key: Decreases the value by 1.
Repeat the above two steps to adjust the differential value for the other im-
age.
5. Select OK.
The settings will be registered and the screen in (1.) will return.
Change the detailed conditions if required when matching is not stable.
1. Select Detailed conditions.
1.Fine matching
The Detailed Conditions Settings Screen will be displayed.
Detailed conditions
Refer to page 1-(26) for information on inputting values.
2. Make the settings for each item.
Refer to the next page for details.
Difference:[ 50]
:Switch image
Measurement conditions
Labeling
Model registration
Judgement conditions
Differencial image
Detailed conditions
Coordinate mode
Model reference
Boundary level : [3]LVL
Perturbation : OFF
Normalization :
OFF
Defect display :
Simple
End
Section 1-6
OK