Table of Contents
Advertisement
EC Circle Count
2-19-5
Registering Circle Sizes
CHECK
SeeAlso
There are two methods for registering the size of the circle.
Registration
method
Input figure
The measurement object is displayed on the screen, a circle is
drawn on the exterior edge of the object and the size of the circle
is registered.
Input parameter
The radius of the circle and the permissible range are entered as
parameters (in pixel units).
The size of the circle registered here is used to find circle candidates.
If circles of different sizes are found or if the inspection is otherwise unstable,
set the radius (radius of circles to be counted) under detailed conditions.
Refer to page 2-19-(14).
Inputting Figures
1.
Select Candidate radius.
1.EC circle count
The registration selections will be displayed.
2.
Select Input figure.
The screen for drawing figures will be displayed.
Input figure
3.
Specify the center position of the circle.
Up/Down/Left/Right Keys:
ENT Key:
Details
Measurement image
Extract edges
Measurement conditions
Inspected region
Candidate radius
Judgement conditions
Detailed conditions
Coordinate mode
Input figure
Input parameter
Move the cursor.
Confirms the setting.
Section 2-19
136,172
2-19-(10)
Advertisement
Chapters
Table of Contents
