Omron F250-UME Software Manual page 414

EC Positioning
CHECK
SeeAlso
2-16-(31)
Limits of length : Set the permissible range for the length.
@
Example: To extract the 4
cross points shown below
To find the coordinates of the cross point of lines regardless of their length,
set Specifying length to OFF. The settings of the line lengths and the limits
of the length will be ignored.
Setting item
Specifying length ON, OFF*
Length @
Limits of length @ 1 to 200 (80:120*)
The asterisk (*) indicates the default setting.
4. Select the sorting conditions for determining which cross point coordinates
will be output. Up to 20 points can be obtained. The coordinates for the first
point matching the selected conditions will be output. (X ascending*, X de-
scending, Y ascending, Y descending)
The asterisk (*) indicates the default setting.
To output the coordinates for the second and subsequent points or to out-
put the center, use Calculation or other processing items and set the for-
mula.
Refer to
Example: Find the average of 4 points to output the center point.
5. Only one angle ( ) will be output as the measurement results for the lines
that are found. Select which position
considered are the two lines meeting the intersection point.)
Set the Length 1 and Length 2 to the
lengths for the areas indicated in the
following diagram.
Selections
1 to 999
.
Center
will be obtained. (The lines that are
Section 2-16
Length 2
Length 1