Omron F250-UME Software Manual page 53

Basic Operations
1-6-3-2 Changing Labeling Conditions
Labeling
Area :
[ 0.000 : 247808.000 ]
Sort :
Area descending order
Label No. :[ 0]
End
Conditions for reassigning label numbers
Area descending order:*
Area ascending:
Gravity X descending:
Gravity X ascending:
Gravity Y descending:
Gravity Y ascending:
The asterisk (*) indicates the default setting.
Note When X and Y center of gravity are sorted, the upper left corner of the screen is the origin.
0
Y
Sort example:
Labeling result
When Labeling area is selected as the defect inspection method, the following
labeling conditions can be changed to match the inspection goals.
Area range for labels (0 to 9,999,999.999 (0 to 247,808.000*))
Label number for which to inspect for defects (0 to 999 (0*))
Sorts in descending order by area.
Sorts in ascending order by area.
Sorts in descending order by center of gravity X coordinate. (See note.)
Sorts in ascending order by center of gravity X coordinate. (See note.)
Sorts in descending order by center of gravity Y coordinate. (See note.)
Sorts in ascending order by center of gravity Y coordinate. (See note.)
The coordinate system set under
X
calibration will not be affected.
Label numbers in
descending order
by area
1 2
1. Select Labeling.
1.Fine matching
Label numbers in
ascending order by
X center of gravity
0
0 1 2
Measurement conditions
Labeling
Model registration
Judgement conditions
Differencial image
Detailed conditions
Coordinate mode
Model reference
Section 1-6
Label numbers in
descending order by
Y center of gravity
2
1
0
1-(45)