Table of Contents
Advertisement
EC Position Compensation
CHECK
2-6-(16)
4.
Only one angle ( ) will be output as the measurement results for the lines
that are found. Select which position
Midline of Corner*
The asterisk (*) indicates the default setting.
Side 1 and Side 2
With the target color between the two sides, the side in the clockwise di-
rection is side 1 and the side in the counterclockwise direction is side 2.
If both the specifying angle and the specifying length are set to OFF and there
are multiple lines displayed on the screen, the cross point of the longest line
and the line that crosses it will be found.
1.
Display the figure selections using the same procedure as outlined under
steps (1.) and (2.) for Circle.
New registration(Position0)
2.
Select Cross point.
The initial screen for cross points will be displayed.
3.
Select Measurement conditions.
will be obtained.
Obtained midline between
two sides.
Side 2
Side 1
Circle
Cross point
Box
Multi-points
Measurement conditions
Line conditions
Search region
Reference registration
Clear
Section 2-6
Advertisement
Chapters
Table of Contents
