Installing The Application Software; Starting The Setup Menu - Omron F250-UME Software Manual

Installing the Application Software

1-3 Installing the Application Software
1-3-1

Starting the Setup Menu

Camera
Power supply
CHECK
CHECK
1-(4)
This section describes how to install the processing items in the F250-UME
Application Software to the Controller. The Setup Menus are used to install
these processing items.
1. Check that the basic components are connected.
Always refer to the Setup Manual when connecting components or wiring the
power supply or ground wires.
2. Mount the F250-UME Application Software Card to Memory Card slot 0.
3. Turn ON the power supply switch to the Monitor.
4. Turn ON the Controller power supply.
The Language Selection Screen for the Setup Menus will be displayed.
Language
The language selected here applies only to the Setup Menus.
Monitor
Console
Japanese
English
Section 1-3
POWER
SYNC