Edge Position - Omron F250-UME Software Manual

Edge Position

2-17 Edge Position
2-17-(1)
The Edge Position processing item uses the density (brightness) in the mea-
surement region to find the position of the measurement object.
Use this processing item to find the edge coordinates or width of the measure-
ment object.
The edge is found using density changes in the measurement region.
Measurement region
The width can be found if multiple regions are registered.
Region 0
Example: Finding the size of a molded product.
To find the X coordinate of this edge
Width*
* The width is found using Calculation.
Section 2-17
Region 1