Omron F250-UME Software Manual page 576

Lot Number OCV 1
2-24-6 Setting the Inspection Region
Automatic Extraction Mode
CHECK
SeeAlso
2-24-(23)
Set the region in which numbers are to be extracted.
The setting method depends on the extract mode (automatic/fixed) set as a
measurement condition.
1. Select Inspected region.
An arrow cursor will be displayed.
Inspected region
2. Draw the inspected region as a square block.
Specify the upper left and lower right coordinates.
Up/Down/Left/Right Keys:
ENT Key:
Draw the region so that only the target numbers fall within the region. Use
End Image to remove anything other than the target numbers that overlap
either vertically or horizontally on the inspected region.
Refer to page 2-24-(13).
If the edges overlap both vertically and horizontally, the numbers cannot be
extracted correctly. If the edges overlap in both directions, adjust the posi-
Inspected region
Set one inspected region.
The numbers will be automatically extracted from
this region. The following settings are used when
extracting.
Extract conditions/Extraction method: page 2-24-
(9)
Extract conditions/Dilate level: page 2-24-(12)
Extract conditions/Noise conditions: page 2-24-(13)
1.Lot-No. OCV1
Measurement image
Extract conditions
Font
Measurement conditions
Reference date
Inspected region
Judgement conditions
Reference number
Move the cursor.
Confirms the setting.
Section 2-24
35,175