Omron F250-UME Software Manual page 162

EC Position Compensation
STEP 3: Setting Search Regions
CHECK
SeeAlso
2-6-(24)
1. Select Line conditions.
Position0(Box)
The Line Conditions Settings Screen will be displayed.
Line conditions
2. Make the settings for each item.
3. Select End.
The settings will be registered and the screen in (1.) will return.
Set the region to search for the positioning mark.
Adjust the search region if there are areas that are not to be included in box
searches.
When edges are extracted, the pixels at the edges of the screen cannot be
processed accurately. Do not include the outer edges of the screen when set-
ting the search region.
Refer to page 2-6-(9) under
1. Select Search region.
Position0(Box)
Measurement conditions
Line conditions
Search region
Box size
Reference registration
Clear
:
Extract level
:
Specifying angle
:
Line angle 0
Line angle 1 :
:
Line angle 2
:
Line angle 3
End
.
Measurement conditions
Line conditions
Search region
Box size
Reference registration
Clear
Section 2-6
3
OFF
[ 0]
[ 90]
[180]
[270]