Omron F250-UME Software Manual page 361

EC Defect
HELP
CHECK
2-15-3-4 Clearing Removal Regions
Input Parameter
1. Select Direction.
Removal region0(Oriented line)
The selections for the registration method will be displayed.
2. Select Input parameter.
The setting screen will be displayed.
3. Set the parameters so that the lines that are not needed are removed.
Angles: See page 2-15-(27).
The latitude of angle is set on both sizes of the angle. For example, if the
angle is set to 180 and the latitude is set to 15 , lines at 165 to 195 will
be removed.
4. Select OK.
The settings will be registered and the screen in (1.) will return.
The clear operation is performed separately for each region.
Removal region
Direction
Clear
Input figure
Input parameter
Latitude
Section 2-15
angle:[ 15]
Angle:[180]
OK
2-15-(28)