Omron F250-UME Software Manual page 68

Basic Operations
1-6-5-2 Test Measurement
SeeAlso
1-6-5-3 Changing Results Display
1-(60)
Use the following procedure to execute measurements according to the condi-
tions set for the scene currently displayed. The test is completed internally by
the Controller and the measurement results are not output via serial or parallel
interfaces. The measurement commands can be input, however, via serial or
parallel interfaces.
Refer to SECTION 6 Communicating with External Devices.
1. Press the TRIG Key on the Console or input the measurement command
from an external device.
Overall judgement
0.Scn 0
Measurement will be executed and the measurement results displayed on
the screen.
Detailed measurements results can be displayed on the screen in Monitor or
Run mode. This is useful when adjusting measurement conditions.
1. Press the SHIFT+ESC Keys.
0.Scn 0
The screen for changing the measurement display settings will be dis-
played.
0.Scn 0
Measurement time
OK 67ms
MON
Image 0 freeze
MON NG
Image 0 freeze
MON NG
Image status :
Freeze(Before scroll)
Display image
:Image0
Image size
: All
Display results : None
End
Image 0 freeze
Section 1-6
67ms
67ms