Omron F250-UME Software Manual page 872

Normal Serial Interface
6-2-2-18 SCNLOAD: Scene Load
Function
CHECK
6-2-2-19 SCNLOADM: Scene Load Memory Card
Function
6-2-2-20 SCNSAVE: Scene Save
Function
6-2-(22)
Loads scene data from an external device.
Input
SCNLOAD <scene number> Delimiter
Specify a scene number between 0 and 31.
Output
Command executed correctly:
Command not executed correctly:
The data transfer is performed with XMODEM (-CRC or SUM) or ZMODEM
protocol. (The XMODEM (-1K) protocol is not supported.)
The Controller sends the character string "READY" to the external device
when the Controller has completed preparations. Wait for the "READY" string
to be received at the external device before starting the data transfer.
Example
This example loads scene data from the external device to scene 2.
Input SCNLOAD 2 Delimiter
Output OK Delimiter
Loads scene data from a Memory Card.
Input
SCNLOADM <scene number> <file name> Delimiter
• Specify a scene number between 0 and 31.
• Specify the drive (C0 or C1) at the beginning of the file name.
• Specify the absolute path from the root directory.
• Add the filename extension .SCN to the filename.
Output
Command executed correctly:
Command not executed correctly:
Example
This example loads the file "LABEL.SCN" to scene 2 from Memory Card 0
directory DIR01.
Input SCNLOADM 2 /C0/DIR01/LABEL.SCN Delimiter
Output OK Delimiter
Saves scene data to an external device.
Input
For XMODEM transfer: SCNSAVE <scene number> Delimiter
For ZMODEM transfer: SCNSAVE <scene number> <filename> Delimiter
Specify a scene number between 0 and 31.
OK Delimiter
ER Delimiter
OK Delimiter
ER Delimiter
Section 6-2