Output Format (Normal) - Omron F250-UME Software Manual

Normal Serial Interface
6-2-3

Output Format (Normal)

Outputting ASCII Data
Output Format
CHECK
SeeAlso
Condition Settings
12345.678 , 567.321 , - 76.912 , ------------ , 65987.165
Data 0
measurement
CHECK
CHECK
When Normal data is set to a unit, the measurement results are output by out-
put number in ascending order. Measurement results are output using normal
communications when the communications mode is set to menu operation.
<Data 0 measurement>, <Data 1 measurement>, - - -
<Data 7 measurement> Delimiter
Settings such as the data format, number of digits, and data delimiter can be
changed as necessary. The following table shows the default settings.
Refer to the
Item
Output format
Digits of integer
Digits of decimal
Minus
Field separator
Record separator
0 Suppress
Example
This example shows an example data output.
Data 1 Data 2
measurement measurement
Field separator
The field separator is required in order for the output to continue to the next
data field.
• Digital Output Range
-9,999,999.999 measurement
The minimum value of "-9,999,999.999" will be output for measurements
less than -9,999,999.999.
The maximum value of "9,999,999.999" will be output for measurements
greater than 9,999,999.999.
• JG (Judgement) Outputs
The following values are output when JG (Judgement) has been set:
OK: 0
NG: -1
After measurements have been made in Run Mode, the data up through the
last measurement will be output even if the mode is changed to another mode.
The data output will not be interrupted midway.
.
ASCII
8 digits
3 digits
-
Comma
Delimiter
OFF (Spaces are inserted in empty digits.)
Data 7
measurement
9,999,999.999
Section 6-2
Setting
Delimiter
Record separator
6-2-(105)