Omron F250-UME Software Manual page 590

Labeling
CHECK
CHECK
2-25-(7)
The Measurement Conditions Settings Screen will be displayed.
Measurement conditions
2. Change the settings.
The settings will be registered and the screen in (1.) will return.
Outside Trimming
Select Outside trimming when there is a white-pixel area inside the mea-
surement region that is not to be measured.
Input image
Measurement
region
Goal: To find the position
and area of this label
Filling Up Holes
Use the Filling up holes setting to specify how areas of black pixels con-
tained inside donut-shaped areas of white pixels are processed. If select-
ed, the black pixels will be processed as white pixels.
Input image
Area :
[ 0.000 : 247808.000
Outside trimming :
Filling up holes :
Sort :
Area descending order
Label No. : [ 0]
End
Outside triming: ON
The area outside the measurement
region changes to white pixels.
(The whole input image area is used
for measurement.)
The position and the size of the middle label
will be found if the following conditions are set:
Sort conditions: Area, ascending order
Label number: 1
Hole filling: ON
Section 2-25
]
OFF
OFF
Measurement target