Omron F250-UME Software Manual page 219

Circle Position Compensation
The screen for specifying the radius will be displayed.
Model registration
4. Specify the size of the circle.
Left Key: Decreases the size.
Right Key: Increases the size.
5. Press the ENT Key.
The screen for registering the size of the model will be displayed.
Model registration
6. Adjust the size of the model.
Right Key: Increases the size horizontally.
Left Key: Decreases the size horizontally.
Down Key: Increases the size vertically.
Up Key: Decreases the size vertically.
When the size of model 0 is adjusted, models 1 to 3 will also change to the
same size.
7. Press the ENT Key.
A settings screen for the rotation positioning range will be displayed.
Model registration
Section 2-9
70
39,39
100
2-9-(16)