Omron F250-UME Software Manual page 312

Density Defects
SeeAlso
1
Set mea-
surement
conditions.
STEP 1: Setting Measurement Conditions
SeeAlso
2-14-(14)
tion points so the measurement region can be adapted to suit if the size or
position of the measurement object changes.
Refer to page 2-14-(4).
2 3
Set mea- Register
surement reference
region. values.
Set the conditions for calculating density changes in measurement regions.
The settings are the same as for Defect (Line, Circum, Arc, and Region),
except for the measurement direction.
Refer to page 2-14-(6).
Measurement
direction
Box
Select to detect the defects for
the whole measurement region.
Calculates the variation in den-
sity in the X direction and Y
direction.
X line
Select to detect defects or burrs
in the upper or lower section of
the measurement region.
Refer to page 2-14-(19).
Calculates the variation in den-
sity in the X direction.
Y line
Select to detect defects or burrs
in the right or left section of the
measurement region.
Refer to page 2-14-(20).
Calculates the variation in den-
sity in the Y direction.
(As required) 4
Set
judgement
conditions.
Application
+
+
Section 2-14
5 (As required)
Change
detection
conditions.
Measurement region
+
+
+
+
Measurement region
+
+
+
+
+
Measurement region
+
+
+
+ +
+
+