Omron F250-UME Software Manual page 332

Density Defects
2-14-4 Measurement Screens
SeeAlso
CHECK
Measurement Region and Position Display
2-14-(34)
Detailed measurement values can be displayed on the screen in Monitor and
Run modes. These values are useful when adjusting measurement conditions.
This section describes what kind of information can be displayed for density
defect inspections.
Refer to
Run modes.
Press the SHIFT+ESC Keys on the Run Screen to access the following screen
and change Display results to Details.
0.Scn 0
Use the Up or Down Key to change to the unit for which density defect inspec-
tion is set and the following detailed screens will be displayed.
Use the SHIFT+Right or Left Keys to switch in order between the two
screens.
0.Scn 0 RUN
1.Density defect
Judge:NG
0
+
Region number
RUN
Image status
:
Freeze(Before scroll)
Display image
: Image0
Image size
: All
Display results
: Details
End
NG 45ms
Judgement result for this region
Inspection region displayed in OK
color for OK result and displayed in
NG color for NG result.
Defect position
Section 2-14
for details on Monitor and