Omron F250-UME Software Manual page 979

Serial Interface Menu Operations
Note XMODEM (-1K) is not supported.
CHECK
SeeAlso
Key Input and Console Key Correspondence
Note Changes the serial interface input to normal (no-protocol) mode. This input is
To exit an Ethernet connection, set Mode to Normal and use the normal com-
mand to enter EXIT.
Refer to
Console Key
ESC Key
TRIG Key
ENT Key
SHIFT + ESC Keys
SHIFT + TRIG Keys
SHIFT + ENT Keys
Left Key
Up Key
Right Key
Down Key
SHIFT + Left Keys
SHIFT + Up Keys
SHIFT + Right Keys
SHIFT + Down Keys
F1 Key
F2 Key
F3 Key
F4 Key
F5 Key
F6 Key
F7 Key
F8 Key
F9 Key
--- (See note.)
valid only in Monitor Mode and Run Mode.
.
Input from RS-232C
Key Code
CTRL + [ ($1B)
CTRL + A ($01)
CTRL + M ($0D)
CTRL + I, TAB ($09)
CTRL + T ($14)
CTRL + R ($12)
CTRL + S ($13)
CTRL + E ($05)
CTRL + D ($04)
CTRL + X ($18)
CTRL + F ($06)
CTRL + W ($17)
CTRL + H ($08)
CTRL + Z ($1A)
CTRL + C ($03)
CTRL + V ($16)
CTRL + B ($02)
CTRL + N ($0E)
CTRL + J ($0A)
CTRL + K ($0B)
CTRL + L ($0C)
CTRL + O ($0F)
CTRL + P ($10)
CTRL + Q ($11)
Section 6-4
6-4-(4)