Table of Contents
Advertisement
Labeling
CHECK
CHECK
2-25-(9)
The figure will be registered.
Once three figures have been drawn,
Add will no longer be displayed.
6.
If additional figures are to be drawn, select Add.
7.
Repeat steps 3 to 5 as necessary to create the desired shape.
8.
After drawing is completed, select End.
The measurement region will be registered and the screen in (1.) will re-
turn. The center of gravity (display cursor) and measurement region will be
displayed.
Figures drawn using OR mode are displayed with solid lines and figures drawn
using NOT mode are displayed with dotted lines.
Set the model region so that no more than three areas lie along any one
straight line.
INCORRECT
3
2
1
Region
Add
Figure0
End
Figure 1 (drawn using OR)
Figure 2 (drawn using NOT)
Figure 3 (drawn using OR)
Rectangle (drawn using OR)
Circumference (drawn using NOT)
Circle (drawn using NOT)
4
Section 2-25
Advertisement
Chapters
Table of Contents
