Omron F250-UME Software Manual page 577

Lot Number OCV 1
CHECK
Fixed Extraction
CHECK
SeeAlso
tion and size of the inspected region so that only the numbers to be extract-
ed fall within the inspected region.
Incorrect
When the bottom right coordinates have been set, the screen in (1.) will re-
turn.
Repeat the procedure from (1.) to change the inspected region.
Set the number of digits under Measurement conditions/Lot-No. digits.
Refer to page 2-24-(18).
1. Select Inspected region.
A digit selection screen will be displayed.
When 3 digits have been specified
Correct
Inspected region
An inspected region is set for each digit.
This enables verifying the position of
individual digits.
1.Lot-No. OCV1
Measurement image
Extract conditions
Font
Measurement conditions
Reference date
Inspected region
Judgement conditions
Reference number
Inspected region
1st digit
2st digit
3st digit
Section 2-24
Adjust size of inspected region.
2-24-(24)