Table of Contents
Advertisement
Customizing Operations
5-4-3
Shortening Scene Group Switching Time
Precaution
SeeAlso
Normally, settings data is saved to flash memory and the Memory Card when
scene groups are changed. The time taken to save is, therefore, added to the
time taken to change scene groups. The time to change scene for changes in
measurement setups can be reduced by omitting the save process.
If this function is set to OFF and settings data changed, always save the data
before changing scene groups. When scene groups are changed, data from
the flash memory or the Memory Card is loaded. So if the changed settings
data is not saved, the data will be replaced by the loaded data. Refer to
1.
Enter System mode and select Operation settings.
Refer to
The Menu will be displayed.
2.
Select Save at switch Scn Group.
The Saving at Switch Scn Group Settings Screen will be displayed.
Saving at switch Scn Group
3.
Select ON or OFF.
ON: Saves the data (default)
OFF: Does not save the data
4.
Select End.
The setting will be saved and the screen in (1.) will return.
.
.
Set key operation
Display capture
Save at switch Scn Group
Password
Nonstop/Fast
Save :
ON
OFF
ON
End
Section 5-4
5-(23)
Advertisement
Chapters
Table of Contents
