Ethernet Connections - Omron F250-UME Software Manual

Serial Interface Menu Operations
Note

Ethernet Connections

SeeAlso
6-4-(3)
The Communications (Serial) window will be displayed.
Communications (Serial)
5. Set each parameter to the desired setting.
6. Select End.
The displayed settings will be registered and the System settings menu
(from step 4) will be displayed.
The following table shows the possible communications settings. The as-
terisk (*) indicates the default setting.
Item
Interface Select RS-232C. (from RS-232C* or RS-422)
Baud rate 2,400, 4,800, 9,600, 19,200, 38,400*, 57,600,
(See note 1.) 115,200 (bps)
Data length 7 or 8* (bits)
Parity bits None*, Odd, or Even
Stop bits 1* or 2 (bits)
Mode Select Menu.
Transfer protocol XMODEM*, ZMODEM
(See note 2.)
1. RS-232C standards are not defined for speeds over 20 kbps. Depending
on the cable length, communications may be unreliable at speeds of
38,400 bps and higher when RS-232C is selected. If there are problems
with communications, reduce the baud rate to 19,200 bps.
2. XMODEM (-1K) is not supported.
The operations are the same as for the RS-232C/RS-422 connections.
Refer to
The following table shows the possible communications settings. The asterisk
(*) indicates the default setting.
Item
Interface Cannot be used with Ethernet connections. Any settings will be
ignored.
Baud rate
Data length
Parity bits
Stop bits
Mode Select Menu.
Transfer protocol XMODEM*, ZMODEM
(See note.)
:
Interface
RS-232C
:
Baud rate 38400bps
:
Data length 8bit
:
Parity bits
None
:
Stop bits
1bit
:
Mode Menu
:
Protocol XMODEM
End
Possible settings
Possible settings
Set the same settings that are set
in the personal computer.
Section 6-4
Set the same
settings that
are set in the
personal com-
puter.
Set the same
settings that
are set in the
personal com-
puter.
.