Omron F250-UME Software Manual page 870

Normal Serial Interface
CHECK
6-2-2-14 MODELSET
Function
CHECK
CHECK
CHECK
6-2-2-15 PASSWORD
Function
CHECK
6-2-(20)
The Controller will revert to Normal mode if the Ctrl + Q Key combination ($11)
is input while the Controller is in Menu Operation mode.
Registers the models again for all regions for the specified unit number. (When
the through display is being used, the models will be registered based on the
last image that was measured.)
Input
MODELSET <unit number> Delimiter
Specify the desired unit (0 to 9999).
Model re-registration is enabled only if model position compensation, circle
position compensation, fine matching, pattern inspection, rotation positioning
or ECM search unit numbers are specified. Other unit numbers will be ignored
if they are specified.
Output
Command executed correctly:
Command not executed correctly:
Example 1
This example re-registers the unit 2 (pattern inspection) model.
Input MODELSET 2 Delimiter
Output OK Delimiter
If a unit number other than a model position compensation, circle position
compensation, fine matching, pattern inspection, rotation positioning, or ECM
search unit number is specified, the command will be ignored and only OK will
be output.
Example 2
In this example, unit 1, where binary defect inspection is set, is specified.
Input MODELSET 1 Delimiter
Output OK Delimiter
Model re-registration is executed for the currently displayed Camera image.
Switch to the Camera image for which the model is to be re-registered before
executing this command. Use the Up and Down Keys on the Console to switch
Camera images. Key codes corresponding to the Up and Down Keys can also
be input from a personal computer if the MENUKEY command is executed.
Reads the password.
If the password has been forgotten, the set password can be obtained using
this command.
Input
PASSWORD Delimiter
OK Delimiter
ER Delimiter
Section 6-2