Omron F250-UME Software Manual page 838

Parallel Interface
6-1-(3)
The communications menu will be displayed.
System settings
4. Select Parallel.
The Communications (Parallel) window will be displayed.
Communications(Parallel)
5. The Communications (Parallel) window will be displayed.
6. Select End.
The displayed settings will be registered and the screen in (3.) will return.
The following table shows the possible communications settings.
Item
ON state
Output control None
Hand-
shak-
ing
Sync.
output
Output period
(Effective only when
output control is set to
None.)
Camera settings
Communication
Serial
Display
Normal
Operation settings
Host link
Measurement control
Parallel
Startup mode
Ethernet
Date/Time
System information
: NG:ON
ON state
: None
Output control
:[ 10.0]ms
Output period
:[
Gate ON delay
:[
Gate ON time
:[ 10.0]s
Timeout
:[ 1]
Num. of delay
End
Select whether the OR and DO0 to DO31 signals will
go ON when the judgement is OK or NG.
(The default setting is ON for an NG judgement.)
The Controller outputs the measurement results without
synchronizing with the external device. (This is the
default setting.)
The Controller outputs the measurement results while
synchronizing the transmission with the external device.
The Controller outputs the measurement results while
synchronizing with processing on the line. The number
of STEP signals specified for the Number of delays set-
ting is ignored and measurement results are output on
the next STEP signal.
Set the period for outputting the measurement result.
Set a value between 2.0 and 10,000.0 ms that is
greater than the "Gate ON delay + Gate ON time," and
less than the measurement interval. If the period is
longer than the measurement interval, the output timing
will fall behind as the measurements are repeated. The
default setting is 10.0 ms.
Section 6-1
1.0]ms
5.0]ms
Settings