Display Time - Omron F250-UME Software Manual

Display Time

2-47 Display Time
SeeAlso
CHECK
CHECK
Operational Flow
STEP 1: Selecting the Display Data
The Display Time processing item is used to display the date and time mea-
surement was performed on the screens in Run and Monitor Modes.
Example: Displaying the Time in Combination with Display String and Display
Measure
0.Scn 0 RUN
Difference from reference: 20
02/03 01:23:45
Measurement date and time
This processing item displays the date and time of the measurement on the
screens in Run and Monitor Modes. The calendar in the Controller must be
adjusted and set beforehand.
Refer to
The data set here will be enabled when None or Positions is selected under
System/Display/Display settings/Display results.
Even when the display image is set to be displayed as a reduced image, the
characters will always be displayed in the specified position.
STEP 1
Select the
display data.
Select the format for the date and time display.
Format
MM/DD hh:mm:ss*
MM/DD hh:mm
hh:mm:ss
hh:mm
*The asterisk (*) indicates the default setting.
Measurement details
OK 45ms
Image 0 freeze
.
STEP 2
Set display
conditions.
Display
10/01 01:23:45
10/01 01:23
01:23:45
01:23
Section 2-47
Measurement value
STEP 3
Set display
position.
2-47-(1)