Omron F250-UME Software Manual page 910

Normal Serial Interface
6-2-(60)
EC Defect (Settings Data)
Data
Settings 60 Measurement image
data
0: Image 0
1: Image 1
61 Coordinate mode
0: After scroll, calibration OFF
1: Before scroll, calibration OFF
2: After scroll, calibration ON
3: Before scroll, calibration ON
62 Edge extraction mask size
™
0: 3 3
™
1: 5 5
63 Edge extraction lower limit (10 to 255)
64 Edge extraction upper limit (10 to 255)
65 Removal
region 0
66
67
68
The following settings data is for circle removal.
Settings 69 Removal
data region 0
70
71
72
73
74
75
The following settings data is for line removal.
76 Removal
region 0
The following settings data is for oriented line removal.
77 Removal
region 0
78
The following settings data is common to all measurements.
79 Removal
region 1
to
The following settings data is common to all measurements
Settings 163 Removal
data region 7
to
175
176
The following settings data is common to all measurements
Details
Region upper left X (0 to 511) (See note.)
Region upper left Y (0 to 483) (See note.)
Region lower right X (0 to 511) (See note.)
Region lower right Y (0 to483) (See note.)
Circle color
0: Black
1: White
2: Both
Latitude of angle (0 to 99)
Circle search
0: OFF
1: ON
Circle center X coordinate (0 to 511)
Circle center Y coordinate (0 to 483)
Circumference radius (3 to 512)
Circumference width (1 to 64)
Extracting level
0: Level 1 1: Level 2 2: Level 3
3: Level 4 4: Level 5
Range of angle (0 to 359)
Limits of angle (0 to 45)
Region upper left X (0 to 511)
... (Same as for removal region 0)
Region upper left X (0 to 511)
... (Same as for removal region 0)
Range of angle (0 to 359)
Limits of angle (0 to 45)
Section 6-2