Omron F250-UME Software Manual page 215

Circle Position Compensation
The screen for registering the size of the model will be displayed.
Model registration
6. Adjust the size of the model.
Right Key: Increases the size horizontally.
Left Key: Decreases the size horizontally.
Down Key: Increases the size vertically.
Up Key: Decreases the size vertically.
When the size of model 0 is adjusted, models 1 to 3 will also change to the
same size.
7. Press the ENT Key.
The registration frame for model 4 will be displayed.
Model registration
8. Enclose the rotation positioning mark.
A confirmation screen will be displayed.
Model registration
ENT:Register ESC:Cancel
9. Check that an appropriate position has been registered as the model.
10. Press the ENT Key.
The settings will be registered and the screen in (1.) will return.
39,39
A
333,209
A
A
Section 2-9
2-9-(12)